Tendzone TYCHO T 1212/CA - Manual (Page 49)

2.12.2Speaker Manager
Figure 47
(1) EQ
There are 8 bands for output parameter equalizer and each band can individually adjust center frequency, gain and Q value
(bandwidth) to reinforce or weaken the signal in some bands and accordingly to achieve different effects. Each point on
the equalizer can be dragged without limit. The parameters for the selected band will change accordingly.
- Flatten All : restore all bands to the status at 0 dB.
- Band Bypass: after adjusting EQ, a user can cancel the bypass which has been set for some bands. A user can restore a
band to the status at 0 dB by selecting the corresponding button to that band. Bypass can only affect the band and cannot
affect others.
- Center Frequency: the frequency to be balanced. When some numbers need to be changed, the graph in the graphic
equalizer will be accordingly synchronized.
- Gain: the gain/attenuation in a center frequency. When this value is 0, both the center frequency and Q value are
invalid.
- Q Value: frequency band block. The greater the value is, the greater the bandwidth will be.
(2) XOVER (Crossover)
Xover can distinguish the sound signals of different frequencies.
- High-Pass Flat: bypass switch to prevent signal from being processed by a high pass filter; the selection of this item
indicates the channel does not start the filter.
- Low-Pass Flat: bypass switch to prevent signal from being processed by a low pass filter; the selection of this item
indicates the channel does not start the filter.
- High-Pass Gain: the gain/attenuation output by a high-frequency signal after processed.
- Low-Pass Gain: the gain/attenuation output by a low-frequency signal after processed.
- High-Pass Frequency: frequency settings for high pass filter.
- Low-Pass Frequency: frequency settings for low pass filter.
(3) Output Gain
If “MAIN BYPASS” is selected, the limiter will be enabled, otherwise, it will be disabled. The output gain control parameter
settings are mainly adjusting the output gain. The output gain after a series of functional processing above mentioned can
be adjusted by changing the setting value.
- Input Level: shows the input signal before it is processed by the speaker manager module.