Thunder Tiger GT5.2 USB Interface Dongle - Manual (Page 2)

Under Mac OS or Linux, the connection should be
identified as “/dev/cu.SLAB_USBtoUART“ if driver have
been installed and interface is plugged in.
Step 4-1:
Plug the dongle to GT5 term channel(CH7) refer the
connection to PC.
Step 4-3:
Please plug power to GT5.
Step 4-4:
Firmware update finished.
Step 4: Firmware update
Step 3-2:
The name “USB to UART Brige” may be different on
your PC. This entry must disappear when you disconnect
the GT5 Interface from the PC, and reappear when you
connect it again.
Step 3-1:
For computer running Microsoft Windows
After successful installation of the driver, when the GT5
interface is connected to the PC, you must be able to find
following entry in the Windwos Device Manager:
Important for using the software is that the correct port
for the GT5 interface was selected. Otherwise you can not
connect the GT5 and firmware update can not be
performed.
Step 3: Comport for GT5 interface
JC2157
Manufactured by
THUNDER TIGER COR
http://www.thundertiger.com
Step 4-2:
Make sure use the correct COM port and choose
update firmware *.gt5upd. Follw the step.
Step 3-3:
You can set Comport in GT5 Tools “Options” function.
Or click Autodetect button.
Step 4-5:
After connect the dongle and power. Click connect to
GT5 to establish a connection to the device.