Tri Tool Boilermaster Beveler Standard - Manual (Page 18)

18
TRI TOOL INC.
92-0629 : Rev. 080714
NOTE:
CAUTION:
CAUTION:
WARNING:
Verify a clearance of 1/8” (3 mm) minimum between the tool bit and the pipe face.
Select the tool bit(s) required to machine the pipe to the configuration desired.
Use of dull or improperly designed tool bits or tool bits not manufactured by
TRI TOOL INC. may result in poor performance and may constitute abuse of
this machine and therefore voids the TRI TOOL INC. factory warranty.
When performing any multiple machining operation such as facing and beveling, the
facing tool bit should be installed as shown above.
Insert the tool bit(s) into the slot(s) in the cutting head.
The cutting edge of the tool bit(s) must be located on the radial centerline.
Insure that no tool bit is installed backwards.
Make sure that there is a clearance between the tool bit(s) and the mandrel.
Tighten the wedge screws or set screws to secure the tool bit in the slot.
Adjust the bevel tool bit radially to control the land width.
OPERATION
Attach the proper air supply line to the BOILERMASTER™
Check that the filter/regulator/lubricator (FRL) is installed and set properly.