DYSON CRO2 - Manual (Page 18)

Self clean cycle (on selected models only)
Cleaning
Maintenance
• The soap tray cavity in the machine should be cleaned out
with a small, soft brush, taking care not to dislodge the
rubber seal.
• Replace the soap tray ensuring it ‘clicks’ into place.
Do not:
• wash the soap tray in a dishwasher.
Maintenance wash
To prevent odours and build-up of deposits within the
washing machine, it is recommended that you run an empty
85 ˚C cotton cycle with a half measure of detergent 2 or 3
times a year. This cycle can be used in addition to the Self
clean cycle (selected models only).
If the outer door is dislodged from its safety hinge:
1 Locate the top ring of the outer door into the top of the
safety hinge.
2 Lift the door and push it forward until the lower ring of the
door ‘clicks’ into place.
The outer door is designed to ‘pop’ out of its hinge if leant
on, however it is not designed to support a load.
10 01
Always:
• disconnect the machine from the mains before cleaning or
carrying out any maintenance work.
Do not:
• clean the machine with detergents. Always use a clean, soft,
damp cloth.
Cleaning the soap tray
• Remove the soap tray by pressing the yellow release button at
the back of the tray, and pulling it out.
• Wash it in warm water with a small, soft brush, taking care
not to scratch the soap tray front.
• Approximately every 200 cycles, the machine will display ‘Self
clean cycle due’. This message will be displayed at the end of
a finished wash cycle. The self clean cycle is a hygenic cycle
which will kill most bacteria in the machine. You can decide to
activate or cancel the Self clean cycle:
• Unload the machine as self clean cycle washes at 85 ˚C
• To activate, put half a measure of detergent into the soap tray,
then press ‘Start’.
• To cancel, press and hold ‘Cancel’.
8887_CRO2_OPS_INNERS.qxd 5/11/03 3:28 pm Page 16