DYSON CRO2 - Manual (Page 19)

Coin trap
Maintenance
5 Remove any objects from the coin trap.
6 If any more items seem to be blocking the coin trap,
pull out the flow accelerator cap.
• Remove any items and firmly push the flow accelerator cap
back into place.
To replace the coin trap window:
• Ensuring the seal is in place, lubricate with a drop of washing
up liquid.
• Make sure the plug is pushed back into the closed position.
• Line up the ears at 12 o’clock position and rotate 360°
clockwise until it clicks into child proof tab at top.
10 02
Never remove any objects from the coin trap while the
washing machine is switched on, still running or paused
during a wash. Always cancel cycle, switch off machine
and allow the water to cool before opening the coin trap.
• Empty the coin trap when a blockage has occurred.
1 Place a tray or shallow dish underneath the coin trap.
2 Using the Dyson spanner, lever the plug in the middle of
the coin trap. The water will drain from the plug.
3 If the tray or dish is full, push the plug into its original position
by hand, empty the tray or dish and repeat the process.
4 Once the water has been removed (a small quantity of water
will remain below the level of the plug), lift and hold the
childproof tab using a small screwdriver or the reverse end
of the Dyson spanner. Turn the window anticlockwise until it
is released.
Childproof tab
Coin trap window
Flow accelerator cap
Plug
Side view: lever spanner through 45 o
Always wash hands after handling the coin trap.
8887_CRO2_OPS_INNERS.qxd 5/11/03 3:28 pm Page 17