TS Performance 1110304 - Manual (Page 3)

Continued
7. Use a wrench to unscrew supplied nut in
order to remove valve cap. Be careful to
hold end of valve while doing this! It is
spring loaded and you don’t want to lose
parts!
8. Removing metal spring, then insert the 3
supplied metal shims into valve.
9. Replace valve spring and then cap. Note
that there are 3 holes in a triangle
position on the inside of the valve cap
that does not need to be removed from
cap and should face towards spring as it
did when it was removed, hole
alignment is not necessary.
10. Place valve back in vice, now with a
thick piece of cardboard or piece of
wood behind valve cap to prevent
damage to the valve seal surface.
Tighten vice so that the valve cap
reenters valve until fully seated. No need
to over-tighten; just tighten until snug.