TW Steel CEO Canteen Chronograph - Manual (Page 3)

USE OF THE CROWN
To adjust the time or set the date, unscrew the
crown cap by turning it anti-clockwise. Once you
have unscrewed it, you will see the (small) crown.
After adjusting, screw the crown cap back by
turning it clockwise.
ADJUSTING THE TIME
Pull the crown out to the 2nd position so that the
second hand stops at the (0) position. Turn the crown to
set the hour and minute hands.
ADJUSTING THE DATE
Pull the crown out to the 1st position. Turn the crown
anti-clockwise to set the date. After the date has been
set, push the crown back to its normal position.
USING THE CHRONOGRAPH
The chronograph is able to measure and display the time accurately
to 1/20th of a second, up to a maximum of 59 minutes and 59
seconds. The retrograde chronograph 1/20 second hand keeps
running continuously for 30 seconds after starting and then stops
at the (0) position. Press button B to change the watch to the
chronograph mode.
The second hand stops at the (0) position and changes to the
chronograph 1/20 second hand.
The chronograph can be started and stopped at any time by pressing
button A. Pressing button B resets the chronograph. All hands will
then return to their (0) position. The second hand can be restarted by
pressing button B once again.
(0) position Hour hand
Chronograph minute
hand
Chronograph
second hand
Second hand
Date Button B
Crown cap /
normal crown
position
24-hour hand
Minute hand
Button A
If the chronograph second hand and the chronograph 1/20 second
hand do not return to the (0) position after the chronograph has
been reset or after the battery has been replaced, you should do the
following. Pull the crown out to the 2nd position. Press button A to set
the chronograph second hand to the (0) position.
Press button B to set the chronograph 1/20 second hand to the (0)
position. The chronograph second hands can be advanced rapidly by
continuously pressing button A or B. Once the hands have returned to
the (0) position, return the crown to its normal position and screw the
crown cap clockwise back to the case.
CAUTION : IF THE CROWN IS NOT PRESSED IN PROPERLY, THE WATCH IS NO LONGER
WATERPROOF AND THE MOVEMENT CAN BE SERIOUSLY DAMAGED!