Venstar T1075 User Manual
Page 31
About Advanced Features & Operation
HEAT/COOL DIFFERENTIAL - The Heat and Cool set-
points will not be allowed to come any closer to each
other than the value set in Advanced Setup step #10, on
page 21. This minimum difference is enforced during
Auto-changeover and Program On operation.
ENERGY SAVING SMART FAN -
matically de-energizes the fan during an Unoccupied
time period, except when necessary to heat or cool
(see page 29).
This feature auto-
70
unoccupied
Pm
Mo
I2:00
76
68
C
OOL
H
EAT
Note: The fan will not de-energize during an Un-
occupied time period if it has been programmed for
continuous operation (step #7, page 20).
Page 30
Note: To increase the spread between the heating and
cooling setpoints in the Auto-changeover mode press
the MODE button until only the heat setpoint is display-
ed; adjust to the desired setpoint. Press the MODE
button until only the cool setpoint is displayed; adjust to
the desired setpoint. Press the MODE button again to
enter the Auto-changeover mode where both the heat
and cool setpoints are displayed.