Venstar T2300FS - Manual (Page 23)

About Advanced Features & Operation
73
eh
74 H EAT
Mo
I2:00
EMERGENCY HEAT - Only available if you have a Heat Pump
installed. To initiate the Emergency Heat feature, press the OVERRIDE
button. While holding the OVERRIDE button press the UP button. The
Cool setpoint display will read ‘EH’ (emergency heat).
Press for
Emergency Heat
OVERRIDE
Operation - During Emergency Heat operation the thermostat will turn on the
fan and the 2nd stage of heat when there is a demand for heat. Also
during Emergency Heat, the 1st stage of heating or cooling will be
unavailable.
Exit Emergency Heat - Follow the same steps as entering Emergency Heat
by pressing the OVERRIDE and UP buttons. During Emergency Heat,
only OFF and HEAT modes are available by pressing the MODE button.
ENERGY SAVING SMART FAN -
continuously during Occupied 1, 2 or 3 and automatically de-energizes
during Unoccupied, except when necessary to heat or cool. To use this
feature, place the thermostat in the Program On mode. Next, program
the fan for continuous operation (step #3, page 15) to display the FanOn
icon (see below). This feature allows the fan to run
70
76
68
occupied
Program
Fan On
On
Pm
C OOL
H EAT
Mo
1
I2:00
Progra
Fan On
Pm
Page 22