DeVilbiss WG1530 - Manual (Page 9)

9
READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS IN THIS
MANUAL BEFORE OPERATING.
OPERATING INSTRUCTIONS
until engine runs smoothly and then move to "No
Choke Position".
8. Pull trigger on gun to start pressure exiting from end of
wand. The pressure washer may need to be re-primed
if it has not been used for awhile. To do this hold the
wand trigger in and turn the pressure regulator knob
low to high several times until the unit will maintain
pressure at the highest setting. (See pg. 8 - no. 11)
9. Adjust Low-High pressure at nozzle. Push nozzle
forward to siphon soaps and cleaners. Pull nozzle
back for high pressure water spray. Adjust pressure
regulator knob on pump to vary water pressure.
10. Adjust spray pattern from wide to narrow by rotating
nozzle.
11. For liquid soaps and cleaners, place suction tube in
your liquid container. Push the wand nozzle forward
to siphon liquid. Adjust detergent regulator on pump
to vary detergent flow.
12. : When you are finished spraying, move
toggle switch on engine to "OFF" or "STOP" position to
turn engine "OFF". Pull wand trigger to release pres-
sure. Do not allow washer to run more than 5 minutes
without pulling trigger.
1. Do not start engine until you have read all warnings
and instructions.
2. Fill oil sump or check oil level. Add "unleaded"
regular gasoline, slowly, to fuel tank. Use a funnel to
help avoid spillage. Never fill tank completely, fill
tank to 1/2" below bottom of filler neck to allow for
fuel expansion.
3. Connect wand to gun and hand tighten. Connect high
pressure hose to gun body and tighten with wrench.
Apply teflon tape if fittings leak.
4. Connect garden hose to washer using adaptor
supplied with unit. Hand tighten. Connect high pressure
hose to washer and hand tighten. Turn pressure regula-
tor knob counter/clockwise to reduce starting load.
5. Turn on water. Pull trigger on gun until there is a steady
stream of water to remove air that might be trapped in
hoses and pump. Operating unit with water supply
shut-off without flow of water will result in equip-
ment damage.
6. Set toggle switch on engine to RUN position, move
choke to "Full Choke Position".
7. Grasp starter handle and pull rope out, slowly, until it
pulls harder. Let rope rewind slowly. Then pull rope with
a rapid full arm stroke. Let rope return to starter slowly.
When engine starts, move choke lever to "1/2 Choke"
DO NOT POINT WAND AT SELF OR OTHERS.