Watson-Marlow PF22 - Manual (Page 34)

Operators Manual
PF22
PF22 OM EN 74-132-005 v1.02.doc Version: 1.02 Page 34 of 34
10 Cleaning and maintenance
10.1 Daily cleaning
As PF22 is not in direct contact with the dispensed product, daily cleaning will not be necessary
except for the normal routine cleaning of production equipment.
When cleaning, please note that the cabinet of PF22 is provided with open slots for the cooling of
the built-in parts. Therefore, liquids must NOT be splashed onto PF22. It may only be cleaned with
a damp piece of paper or cloth.
The cabinet is made of anodized aluminium, and normal cleaning agents such as tepid/medium
hot water, ethyl alcohol (ethanol) 70% and may be used all over the machine.
10.2 Sterilisation
If PF22 is placed in an aseptic environment, the sterilisation may be made as described in section
8.1, or you may sterilise PF22 by gases observing the following precautions.
If you use gasses that might injure and corrode contacts and other metals, air slots and sockets
MUST be covered with tape.
10.3 Maintenance
As all movable parts in PF22 are maintenance-free, no maintenance is required apart from normal
cleaning of the equipment.
If service should be needed, please contact your supplier or Flexicon A/S.
Disposal:
The PF22 contains lithium batteries. The machine can be disposed in the same way as Personal
Computers.
COPYRIGHT
****************
Copyright (c) 2012 Flexicon A/S. All rights to this manual belong to Flexicon A/S. Neither the
complete manual nor parts of it may be translated, copied, printed or published in any form or by
any means without permission in writing from Flexicon A/S
Flexicon A/S is convinced that the information of this manual is correct, but Flexicon A/S can not
be held responsible for it.
Flexicon A/S reserves the right to update and amend this manual without previous notice.
Flexicon A/S is under no obligation to update manuals already published.