Westermo GD-01 - Manual (Page 16)

16 6196-2220
+CKPD – Keypad control
Description:
This command emulates the ME keypad by sending each keystroke as a character
in a <keys> string.The supported GSM sequences are listed below in this manual.
If emulation fails, a +CME ERROR: <err> is returned. If emulation succeeds, the
result depends on the GSM sequence activated.
NOTE: In the case where the FDN phonebook is activated, the sequences concerning
“call forwarding” are allowed only if the entire sequence is written in the FDN.
Syntax:
AT+CKPD=<keys>
<keys> may be a string of the following characters
0-9,*,# characters allowed in the keypad control string
Command example Possible responses Note
AT+CKPD=”*#21#” +CCFC: 0,7 Check every call
forwarding status
AT+CKPD=”1234” +CME ERROR 3 Sequence not allowed
+CCLK – Clock Management
Description:
This command is used to set or get the current date and time of the ME real-time clock.
Default date/time is “98/01/01,00:00:00” (January 1st, 1998 / midnight).
Syntax:
AT+CCLK=<date and time string>
<date and time string> is a string with the following format:
“yy/MM/dd,hh:mm:ss” Valid years are 98 (for 1998) to 97 (for 2097).
The seconds field is not mandatory.
Command example Possible responses Note
AT+CCLK=”00/06/09,17:33:00” OK set date to June 9th, 2000,
and time to 5:33pm
AT+CCLK=”00/13/13,12:00:00” +CME ERROR 3 Incorrect month entered
AT+CCLK? +CCLK: “00/06/09... current date is June 9th,
2000, time is also reported
B A C K