Eaton Electrical -66103 - Manual (Page 3)

34003906EN/AE - 3
The Network Management Card & Modbus/Jbus (66103) is recommended for central UPSs
protecting entire networks or for UPS units backing up critical loads. With the card installed, the UPS
has its own IP address and uses the local computer capabilities to:
● Supply web pages (http or https (SSL)) with information on status conditions and measurements/
settings/alarms,
● Integrate an SNMP-based NMS such as HP OpenView, IBM Tivoli Netview and Computer Associates
Unicenter,
● Communicate with shutdown modules installed on the protected servers (Network Shutdown
Module),
● Send e-mail and SMS messages,
● Control the ON/OFF function of the UPS and the outlets,
● Monitor the Environment Sensor (optional, cat. no. 66846).
● One Network Management Card & Modbus/Jbus (66103)
● One serial cable for configuration (34003918),
● One installation manual (34003906).
The Network Management Card & Modbus/Jbus (66103) is compatible with the Pulsar range UPSs
available since 2006.Note.
● If the technical level of the UPS is lower than that indicated in the table, contact EATON.
UNPACKING AND CHECKS
CHECK ON UPS VERSION
Important. Before installing the card, check that the UPS technical level (NT) is at least
equal to that indicated in the table below.
UPS Type Technical level (NT)
Pulsar 700/1000/1500 02
Pulsar M 2200/3000 03
Pulsar MX 4000/5000/10000 04
Pulsar MX Frame 15/20 kVA 01
34003906EN_AE.fm Page 3 Vendredi, 19. décembre 2008 1:49 13