Eaton Electrical -66103 - Manual (Page 6)

6 - 34003906EN/AE
The card is configured by default with this service enabled. No manual configuration is required.The IP
parameters are automatically collected by the card.
From the main configuration menu: (see above)
● Press the 2 key (Network configuration).
● Press the 1 key(Read Network settings).
The settings supplied by the server are displayed:
● Note the IP address.
● Press the 0 key (Exit).
● Press the 0 key (Exit).
You can also use NMC Tool software utility to view the card IP adress
Provided on the Solution-Pac 2 CD-ROM or at www.eaton.com. It must be installed on a network
connected PC.
Manual configuration is required.
To set the network configuration, use terminal emulation (see above)
From the main configuration menu:
● Press the 2 key (Network configuration).
● Press the 2 key (Modify Network settings).
● Follow the instructions and enter the IP parameters:
Wait until "Done" is displayed, indicating that the IP parameters have been saved.
● Press the 0 key (Exit).
● Press the 1 key (Reset).
● Press the 2 key (Restart).
The card restarts with the new IP settings (after approx. one minute).
Your network is equipped with a BOOTP/DHCP server (default)
Network configuration :
MAC address : 00:06:23:00:1C:07
Mode : DHCP
IP address : 172.17.23.18
Subnet mask : 255.255.248.0
Gateway : 172.17.17
Your network is not equipped with a BOOTP/DHCP server
1 : Read Network settings
2 : Modify Network settings
3 : Set ethernet speed
0 : Exit
For each of the following questions, you can press "Return" to
select
the value shown in braces, or you can enter a new value
Should this target obtain IP settings from the network?
[N] N
Static IP address [172.17.16.16]?172.16.1.82
Subnet mask IP address
[255.255.0.0]? 255.255.255.0
Gateway address IP address [0.0.0.0]? 172.17.17.1
Done
34003906EN_AE.fm Page 6 Vendredi, 19. décembre 2008 1:49 13