Eurotech Appliances EDW274E - Manual (Page 25)

25
ENGLISHENGLISHENGLISHENGLISHENGLISH
MODEL EDW294E OPERATING INSTRUCTIONS
CONTROL PANEL
ON/OFF BUTTON
Press this button to turn on the power to the machine.
The power must be on before you can select the
program and options.
LCD WINDOW
The LCD displays programs, delay start hours, and
program run times. It also displays error codes (see
page 31).
PROGRAM BUTTON
Press the program button until the number for the
program you wish to select displays (e.g., P1, P2,
etc.). The program numbers correlate to the order in
which the programs are shown on the control panel,
starting on the left (Soak and Hold).
OPTION BUTTONS
Please note that you must select the options after
you’ve selected the wash program and before you
start the dishwasher.
Delay Start
You can delay starting the program from 1 to 16
hours. Press this button until the number of hours
you wish to delay starting the program displays on
the LCD. The small light above this button will glow
to indicate that you have selected this option.
Top Load
This option is designed to save water and energy by
allowing your to wash only the top or bottom basket.
The indicator light above this button will glow when
this option is selected. (This option is not available
with the Soak and Hold program.)
Press the Top Load button once to wash the top
basket only. The LCD will display two bars across
the top to indicate the top basket wash has been
selected.
To wash the bottom basket only, press this button twice.
The LCD will display two bars across the bottom to
indicate the bottom basket wash has been selected.
No Prewash
This option lets you turn off the prewash cycle and is
only available for programs with a prewash, i.e., Pots
& Pans and Heavy Wash. The indicator light above
this button will glow to indicate that you have selected
this option.
Dry Time
This button overrides the automatic drying time for the
program you select and lets you specify the length of
time to fan dry the dishes. The indicator light above this
button will glow when you have selected this option.
Your options are 0, 20, 35, or 45 minutes. (The
factory-set drying time is 20 minutes.) The following
defines what the LCD codes for this option are:
A0 = no dry A2 = 35 minutes
A1 = 20 minutes A3 = 45 minutes
START BUTTON
Once you have selected a program and options, press
this button and close the door to start the dishwasher. A
signal will sound to indicate the program has begun and
the LCD will display the estimated program run time.
If you stop a program in progress by opening the door,
you will need to press the Start/Stop button again to
restart the program from the interrupted point.
INDICATOR LIGHTS
The On light indicates that the power to the unit is
on. The Rinse Aid light glows when you need to add
rinse aid. (See page 20 for instructions on how to
load the rinse aid dispenser.)
ADDING AN ITEM
WARNING!
Be extremely careful when opening the door
during a program. The water is hot and you
could get scalded.
To add an item after a program has started, open the
door slightly until the spray arms stop turning. You
can then open the door fully and place the item into
the dishwasher. Close the door and press the Start
button to restart the program from where it stopped.
On/Off
Button
Program
Button
Indicator
Lights
Option
Buttons
Programs
LCD Window
Start
Button