Eurotech Appliances EDW274E - Manual (Page 7)

7
ENGLISHENGLISHENGLISHENGLISHENGLISH
MOVING THE MACHINE INTO PLACE
WARNING! Make sure you put the slides cups under the legs to prevent damaging the
floor or unit when you slide it into place (see page 5).
1. Remove the toe kick from the top of the unit and set it aside.
2. Remove the zip tie holding the hoses and power supply cord in place
on the back of the unit as illustrated at right.
3. Position the unit in front of the cabinet opening.
4. Weave the drain line through the U shaped High Loop bracket and
attach that bracket to the back of the unit or the surrounding cabinets
as illustrated on page 10 of this manual.
5. Start to feed the water and drain lines, as well as the power cord (if
necessary) into the access hole in the cabinet.
6. Grip the unit at the top or side edges and gently slide the unit into the
dishwasher opening using the slide cups provided with the unit under
the rear legs.
WARNING! Never use your knee or shoulder to push
the unit in place. You could damage the
dishwasher.
7. Check the level and make adjustments if necessary. (See above.)
WARNING! Be careful of sharp edges.
OPENING THE EDW294E CUSTOM DOOR
To open the door panel on the EDW294E, insert your fingers into the
rectangular slots on each side of the door and pull.
ADJUSTING THE LEVELING LEGS
You should adjust the levelling legs to within 1/8” of the opening
height. The four leveling legs should be adjusted by unscrewing the
leg out to the length required. When the feet are properly adjusted,
tighten the locking nuts to the base pan.
(The machine may have an inclination of 2° maximum without
affecting its performance.)
WARNING! Never lay the dishwasher on its front or
side. When necessary, lay the unit on its
back.
It is advisable to lay the unit on a tarp or
blanket so as not to scratch or damage the
floor or the dishwasher.
* Use caution when standing the
dishwasher up so you do not break the
legs.
Levelling leg
Locking nut