Airaid 883-275 - Manual (Page 3)

24. Place the Air Box Gasket (#22) onto the face of the
Air Box and align the bolt holes. 26. Place the Air Box assembly into the vehicle with
the Air Box’s Bracket behind the factory bracket as
shown . Connect the factory intake tube to the Airaid
Air Box and tighten the clamp 25. Install the Air Box Top (#3) onto the Air Box using
five 1/4-20 x 1” Hex Bolts (#13), 1/4” Flat Washers
(#14), and 1/4” Lock Washers (#15).
27. Fasten the Transmission Bracket to the transmis-
sion using the two 1/4-20 x 5/8” Hex Head Bolts (#12),
1/4-20 Flat Washers– Large (#16), Trans Mount Wash-
ers (#10), and 1/4-20 Lock Nuts (#17).
Note: It is intended for the Trans Mount Washers to fit
inside the holes in the OEM bracket when properly
installed. 28. Check for clearance between the Air Box and the
transmission linkage by shifting into all ranges. Read-
just the Air Box and Bracket if more clearance is need-
ed and make the bolts final tight.
29. Extend the factory PCV breather.
A.) Connect the supplied 3/8” hose (#27) to the fac-
tory PCV breather using the 3/8” Hose Fitting (#26).
B.) J oin the extended br eather line to the 90 deg.
Fitting in the top of the Air Box and secure using the
Three Speed Clamps (#29).
32. Cut the large hole in the panel using a drill with a
3” hole saw. 31. Drill four 1/8” pilot holes in the panel. 30. Cut out the Air Scoop Template and carefully po-
sition it so that the top and right edges align with the
panels radius. Use tape to hold in position while mark-
ing holes with a punch.
Note:
This step is necessary for both install options using
the Air Scoop or Snorkel.
Page 3
CLAMPS
Trans Mount Washer
Radius edge begins here
33. Drill 5/16” bolt holes in the panel. 34. Reinstall the factory panels and the bed in the re-
verse order in which they were removed. 35. Slide the Hump Hose (#8) and clamps onto the
Riser Tube (#4) as shown. The #52 Clamp (#19) is to
be installed on the Tube side and the #60 Clamp (#20)
on the other. Leave the clamps loose for now.