Filter service, Air inlet scoop option – Airaid 883-275 User Manual
Page 5
48. The Snorkel Tube has a large mounting tab to ac-
commodate many cage options. Determine the best
location for attachment and drill a 5/16” hole. Use the
supplied Loop Clamp and the remaining 1/4-20 hard-
ware (#31,14 & #17) to secure the Snorkel Tube.
DO NOT OPERATE VEHICLE WITHOUT SOME
FORM OF CAGE MOUNTING!
Filter Service
Airaid recommends following the manufac-
turers maintenance schedule for filter clean-
ings.
“
Air filters should be inspected before each ride. Filter and
pre-filter need to be replaced at least annually and more often
if subjected to severe use.”
The Airaid Filter is reusable and
should be cleaned using the Airaid Filter Tune
-Up Kit .
2. Remove the Plug Grommet in the access port and
loosen the filter Clamp. A 1/4” drive ratchet with a 3”
extension and a 5/16” socket works best.
1. Loosen the Clamps on the Hump Hose and slide it
back. Remove the 1/4” bolts and washers from the Air-
box Top and slide out the Top.
Air Inlet Scoop Option
1. Install the Threaded Studs into the Riser
tube.
2. Mount the Air Inlet Scoop.
A.) Slide the Riser Tube with Studs and Gasket
through the panel.
B.) Slide the Air Inlet Scoop(#6) and Air Scoop Gas-
ket (#24) onto Panel and Studs.
C.) Fasten the Scoop to the Riser Tube Studs using
the three 1/4-20 Flange Nuts (#18) and 1/4” Flat Wash-
ers.
3. Insert the Foam Pre Filter (#6) into the Air Scoop as
shown.
The Air Scoop can not be used in conjunc-
tion with the Snorkel.
Pre Filter Option
For maximum protection in the harshest of environ-
ments Airaid offers a slip on Pre Filter.
- Prolongs Cleaning Intervals
- Water Repellant
- Free Flowing Protection
Part Number 799-456
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
Page 5
49. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Reconnect the neg-
ative battery cable and reinstall the seats.
3. The Filter can now be removed for service.
C
Gasket
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!