Airaid 883-314 User Manual
Page 3
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
28. Install the 2” cap and # 28 Hose Clamp onto the fire
wall in the passenger side inner fender (See step 3.).
25. Remove the hood and make the Hood Scoop Fasten-
ers Final Tight.
26. Finish the hood modification by installing the Rubber
Edge Trim (#9) onto the cut edge.
27. Compress and install the Foam Pre Filter (#7) into
the Hood Scoop.
REV.1.29.14
29. Reinstall the center console using the factory hard-
ware and reconnect the battery.
30.
Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Double check the
hood clearance.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!