Airaid 883-315 User Manual

Installation instructions, 315 intake and snorkel, Component identification

Advertising
background image

Installation Instructions

For Part Number:

883-315 Intake and Snorkel

2014

-15 Kawasaki Teryx

2012-1

5 Kawasaki Teryx 4

750 cc

2. Loosen the clamps on the factory airbox couplers.

3. Remove the factory airbox and couplers from the vehi-
cle.

4. Create the Airbox Assembly by sliding the Top Panel
(#2) into the Bottom Panel (#3). Use four of the 8-32
Thread Cutting Screws (#23) on each side to secure the
panels.

5. Use the two remaining Thread Cutting Screws on the
bottom of the assembly shown.

6. Install the Mounting Brackets (#7) onto both sides of
the Airbox Assembly a shown using the four 1/4-20 x
1/4” Button Head Bolts (#22)

8. Tighten the Air Filter clamp though the access port
on the back side of the Airbox.

7. Slide the Airaid Premium Filter (#1) onto the mount-
ing tube inside the Airbox Assembly. Note the location
of the isolator tab on the filter inside of the box.

9. Install the Blind Grommet (#19) into the access port.

Component Identification

1.

Airaid Premium Filter

1

2.

Top Panel

1

3.

Bottom Panel

1

4.

Filter Tray

1

5.

Hood Scoop

1

6.

Foam Pre Filter

1

7.

Mounting Bracket

2

8.

Silicone Coupler

1

9.

Urethane Cap

1

10.

Airbox Lid

1

11.

Snorkel Tube

1

12.

Snorkel Inlet

1

13.

Snorkel Screen

1

14.

Foam Prefilter

1

15.

3” Flexible Duct, 40”

1

16.

48 Hose Clamp

4

17.

Blind Grommet

1

18.

1/4-20 x 1/2” Button Head screw

6

19.

1/4” Flat Washer

16

20.

1/4-20 x 1/4” Button Head screw

4

21.

#8-32 Thread Cutting Screw

10

22.

Edge Trim, 36”

1

23.

Edge Trim, 10”

1

24.

3” Loop Clamp

2

25.

1/4-20 Speed Nut

2

26.

1 3/4” Loop Clamp

3

27.

1/4-20x 1 1/4” Bolt

3

28.

1/4-20 Nylock Nut

3

29.

8-32 x 3/8 Button Head Bolt

4

30.

Torx Screw

4

31.

T-20 Torx bit

1

32.

Bubble Sticker

1

Tools Required For Installation:

In addition to common hand tools, this installation requires the

use of a : Hand drill, 1/2” Drill Bit, Jig Saw, Center punch, and

hammer.

1. Raise the hood of the vehicle. Locate and disconnect
the negative battery terminal underneath the airbox. Re-
move the four airbox bolts and set them aside. They will
be reused in step 11.

Top Panel

Bottom Panel

Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.

Page 1

Advertising