Airaid 250-927 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
www.airaid.com
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY!
5. Install the 3/8” Breather Hose onto the
Barbed Fitting and carefully route it behind
the pulleys following the wiring harness.
Connect the other end of the breather line to
the hard line from step 1. Secure the breath-
er line behind using the two remaining Zip
Ties once you have determined it is safe from
all moving parts
4. Install The New Airaid Intake Tube
into the Hump Hose first, and then into
the Reducing Coupler. Adjust for fit, and
tighten all four hose clamps. Re connect
the Mass Airflow Sensor and secure the
wire harness to the throttlebody harness
using a single Zip Tie.
6. Double check your work!
Make sure there is no foreign material in
the intake path. Make sure all clamps,
hoses, bolts, and screws are tight. Double
check the hood clearance.
Reconnect the negative battery cable.
Instructions Revision
Date: 06/20/11
A Note Regarding Custom Tuning
This intake system is not calibrated to any ECU program and is not to be used without being custom tuned.
Off the shelf aftermarket REPROGRAMERS (Superchips, Hypertech etc.) DO NOT constitute “custom tuning” .
Custom tuning is vehicle specific tuning, for that vehicle, and unique to its modifications. In other words it is ONE OFF programming. Since this tun-
ing is unique to each vehicle, AIRAID can not offer any assistance regarding any Tuning issues .
Failure to properly tune after installation of this system will result in poor performance and possible engine damage.