Extron electronic AVTrac 42-122-xx - Manual (Page 10)

Installation
AVTrac • Installation 8
Step 2: Wall
Cut cable access hole in wall
2-2 Using a drill, box cutters and/or a saw, cut a 4" W x
1½" H (10.2 cm x 3.8 cm) hole at the base of the wall.
If there is a metal base stud, use a hand saw or tin
snips to cut it at both edges of the hole and bend
it back into the hole so that the stud lies flat on the
floor. (Use a file to remove any jagged edges that
might damage cables.)
The hole will eventually be covered by the
baseboard, so it does not have to be perfect.
4" (10.2 cm
)
1½" (3.8 cm)
Mark wall
2-1 If necessary, remove the baseboard from the bottom
of the wall and mark where the AVTrac will abut the
wall.
This manual shows an AVTrac installation with cables being run inside a drywall cavity. If the cables from the AVTrac
system will not be run inside a drywall cavity, ignore this section and go to Step 3 (Track) on the next page.
To run cables from the AVTrac system inside a drywall cavity, follow these instructions: