Allmand Brothers NIGHT LITE PRO LD - Manual (Page 14)

NOTE: NS = NOT SHOWN. WHEN ORDERING, SPECIFY THE COLOR WANTED ON PARTS CONTAINING THE LETTER “P”
14
NIGHT LITE PRO 50-60 Hz
4/14/2011
3/16 X 11’
REMOVE THE CUSHION CLAMPS AND MAST WIRING FROM 3” MAST SECTION.
REMOVE THE WIRE ROPE CLIPS AT TOP END OF THE 4” MAST SECTION.
REMOVE THE 3” PULLEY AT THE END OF THE 3” MAST SECTION.
REMOVE THE 2 5/8” ROUND MAST SECTION.
REMOVE ALL THE BROKEN AND FRAYED CABLE.
REPLACE NEW CABLE THROUGH SLOT AND EYELET IN THE ROUND MAST SECTION.
REPLACE 2 5/8” ROUND MAST SECTION IN THE 3” MAST SECTION.
ROUTE CABLE THROUGH PULLEY AND BRACKETS AND INSTALL 3” PULLEY.
WITH ALL SECTIONS PUSHED TOGETHER TIGHT, INSERT CABLE THROUGH HALF-LINK
AND INSTALL WIRE ROPE CLIPS.
REINSTALL CUSHION CLAMPS AND MAST WIRING ON THE 3” MAST SECTION.
3/16 X 17’ 9”
REMOVE MAST WIRING FROM BALLAST COMPARTMENT.(SEE ELECTRICAL SCHEMATIC)
REMOVE THE CUSHION CLAMPS AND MAST WIRING FROM 4” MAST SECTION.
REMOVE STOP BOLT AND WASHER.
REMOVE 4 TOWER PADS AND 3” PULLEY AT THE END OF THE 4” MAST SECTION.
REMOVE THE 2 5/8” ROUND AND THE 3” MAST SECTIONS TOGETHER.
REMOVE ALL THE BROKEN AND FRAYED CABLE.
REPLACE NEW CABLE THROUGH SLOT AND EYELET IN THE 3” MAST SECTION AND
THROUGH PULLEY BRACKETS.
REPLACE 2 5/8” ROUND AND 3” MAST SECTIONS.
REPLACE 3” PULLEY AND TOWER PADS.
ATTACH CABLE TO WINCH AND WIND IN A CLOCKWISE DIRECTION UNTILL ALL SLACK
IS OUT.
REPLACE STOP BOLT AND WASHER.
REPLACE CUSHION CLAMPS AND MAST WIRING ON 4” MAST SECTION.
REPLACE MAST WIRING IN BALLAST COMPARTMENT.(SEE ELECTRICAL SECHEMATIC)
3/16 X 10’
REMOVE ALL BROKEN AND FRAYED CABLE.
FEED NEW CABLE THROUGH EYELET IN MAST PIVOT SECTION.
INSTRUCTIONS FOR REPLACING STEEL CABLES
NS REQ'D PART NO DESCRIPTION
2 620084 WIRE ROPE CLIP 3/16"
1 045040 WIRE ROPE THIMBLE 1/4"
1 620076 STEEL CABLE 3/16 X 11'
1 650133 STEEL CABLE 3/16 X 17'9"
1 320185 STEEL CABLE 3/16 X 10'
MANUAL LAYDOWN TOWER WINCH ONLY