Allmand Brothers NIGHT LITE PRO LD - Manual (Page 20)

NOTE: NS = NOT SHOWN. WHEN ORDERING, SPECIFY THE COLOR WANTED ON PARTS CONTAINING THE LETTER “P”
20
NIGHT LITE PRO 50-60 Hz
4/14/2011
NS REQ'D PART NO DESCRIPTION
2 620084 WIRE ROPE CLIP 3/16"
1 045040 WIRE ROPE THIMBLE 1/4"
1 620076 STEEL CABLE 3/16 X 10'
1 650133 STEEL CABLE 7/32 X 26'
ELECTRIC LAYDOWN TOWER WINCH ONLY
INSTUCTIONS FOR REPLACING STEEL CABLES
3/16 X 10’
REMOVE THE CUSHION CLAMPS AND MAST WIRING FROM 3” MAST SECTION.
REMOVE LIGHT BAR BY REMOVING 4 NUTS ON AND LAY BAR ON GROUND.
REMOVE THE WIRE ROPE CLIPS AT TOP END OF THE 4” MAST SECTION.
REMOVE THE 3” PULLEY AT THE END OF THE 3” MAST SECTION.
REMOVE THE 2 5/8” ROUND SECTION.
REMOVE ALL BROKEN AND FRAYED CABLE.
REPLACCE NEW CABLE THROUGH SLOT AND EYELET IN THE ROUND MAST SECTION.
REPLACE 2 5/8” ROUND MAST SECTION IN THE 3” MAST SECTION.
ROUTE CABLE THROUGH PULLEY BRACKETS AND INSTALL 3” PULLEY.
WITH ALL SECTIONS PUSHED TOGETHER TIGHT, INSERT CABLE THROUGH HALF– LINK
AND REINSTALL WIRE ROPE CLIPS.
REINSTALL CUSHION CLAMPS AND MAST WIRING ON THE 3” MAST SECTION.
7/32 X 26’
REMOVE CABLE FROM WINCH.
REMOVE MAST WIRING FROM BALLAST COMPARTMENT.(SEE ELECTRICAL SCHEMATIC)
REMOVE TOWER ASSEMBLY FROM TRAILER.
REMOVE STOP BOLT AND WASHER.
REMOVE 4 NYLON ROLLERS AND 3” PULLEY AT TOP END OF 3” SQUARE SECTION.
REMOVE THE 2 5/8” ROUND AND 3” MAST SECTIONS TOGETHER.
REMOVE 2 1/2” PULLEY FROM END OF 4” MAST SECTION.
REMOVE ALL BROKEN AND FRAYED CABLE.
REPLACE NEW CABLE THROUGH SLOT AND EYELET IN THE 3” MAST SECTION AND
TRHOUGH PULLEY BRACKETS.
REPLACE 2 5/8” ROUND AND 3” MAST SECTIONS.
REPLACE STOP BOLT AND WASHER.
RUN NEW CABLE ON OUTSIDE OF 4” MAST SECTION.
REPLACE 2 1/2” PULLEY.
REPLACE TOWER ASSEMBLY ON TRAILER.
REPLACE MAST WIRING IN BALLAST COMPARTMENT.(SEE ELECTRICAL SCHEMATIC)
RUN NEW CABLE TROUGH PULLEY BRACKETS IN FRONT OF TRAILER.
ATTACH CABLE TO WINCH.
WIND IN A CLOCKWISE DIRECTION UNTILL ALL SLACK IS OUT.