Allstar Performance ALL81220 - Manual (Page 4)

Allstar Performance 8300 Lane Drive, Watervliet MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Break-In Period Required
• Prior to completion of installation, the distributor gear should have received a coating of zinc or moly based grease
(grease sold separately). It is the responsibility of the installer to apply this grease.
• Do not use synthetic oil during break-in period. Once break-in period is complete, any suitable oil can be used.
• On modifi ed engines with oil pressure above 70 psi (cold), the gear should be broken-in with racing grade mineral oil.
• Monitor gear wear after several hours of break-in. Check the gear for proper mesh, alignment, and wear.
Limited Warranty
Manufacturer’s obligation for warranty returns shall be limited to repairing, replacing, or crediting as its option, any parts found
to be defective. Manufacturer will not be liable for charges and/or other expenses incurred, nor shall it be liable for damages or
injury to persons or property resulting from the misuse or improper installation of any part subject to this warranty. The warranty
contained herein is expressly in lieu of any and all other warranties, including any implied warranty of merchantability or fi tness
for any particular purpose.
FIG. 4
Advance Stop
Bushing and Pin
Locking Centrifugal
Advance Position
FORM 1031 Page 4 of 4 Rev.071907