ARM Electronics SDKBD1 - Manual (Page 7)

- 4 -
1. Select Address of Speed Dome Camera /Decoder：[N]+[ CAM]
Description：N –– No. of camera from 0 to 64
Function：Select the address of the camera to be controlled. When the value N is in conformity with the
address of the speed dome, it will be under control.
2. To set preset position：[N]+[ PRESET]
Description：N –– No. of preset position from 1 to 64.
Function：Store current position and refer it as No. N position.
3. Call the Preset position：[N]+[ CALL]
Description:：N –– No. of preset position from 1 to 64.
Function： Transfer the camera to the position of No. N preset position.
4. Cancel the Preset position: [N]+[CLEAR]
Description：N –– No. of preset position from 1 to 64.
Function：Delete the No. N Preset position stored.
5. Run patrol：[N]+ [SHOT]
Description：N –– No. of the track from 1 to 3.
Function：Tour the No. N track and stop tour by pushing the joystick.
6. To turn on Auto Pan (Operation of COP-2 SAMSUNG Protocol)：[AUTO]+[P1]+[ON]+[P2]+[OFF]
Description：P1 –– the starting scan No. of preset point from 1 to 64, which should be set already.
Description：P2 – the ending scan No. of preset point from 1 to 64, which should be set already. If P1 =
P2 or P1 and P2 are coincided, the speed dome will make scan in range of 360°.
Note: ① For PELCO-D、PELCO-P、COP-1 Protocol the way of operation is as follows:
‹ Set the starting scan position: Transfer the Speed Dome to the starting scan position, operation
[AUTO]+[ON]
‹ Set the ending scan position: Transfer the Speed Dome to the ending scan position, operation
[AUTO]+[OFF]
‹ Run Auto Pan：[AUTO]+[SHOT]
② Auto Pan operation takes the following parameters. You must set these parameters before using a
Auto Pan command to begin the scan operation. You can use the scan stop command or PT swing
stop command to stop the scan. Setting scan condition.
z Auto Pan Position (First specify position, second specify position)
z Auto Pan Speed and Direction
7. Stop Auto Pan：[AUTO]+[OFF] ( Only C0P-2 Available) or push the joystick to stop scan
8. Patrol setup (COP-1, COP-2, PELCO-D, PELCO-P Available)：
a) Set Patrol Start：[96] + [CALL] Begin to set the No.1 patrol，LED Display L1
[97] + [CALL] Begin to set the No.2 patrol，LED Display L2
[98] + [CALL] Begin to set the No.3 patrol，LED Display L3
b) Insert preset point in patrol：if LED display LN（N: No. of the patrol from 1 to 3.）you can insert
preset point in current patrol. Now you can operate as follow:
[N] + [CALL] (N: No. of preset position from 1 to 64). And you can insert 16 preset point in
maximum
c) Set Patrol Stop: [99] + [CALL]
9. Control the zoom of the Camera：[WIDE]/[TELE]
10. Control the Focus of the Camera：[FAR]/[NEAR]
11. Control the Iris of the Camera：[OPEN]/[CLOSE]