Atlantic Water Gardens PAF-20 - Manual (Page 3)

3
• The pump is a 100/120 volt 60 Hz pump, please only use with a power
supply voltage within 100-120 volt 60 Hz.
• Never place your hand or any object in or near the inlet opening
while this equipment is operating. If pump inlet is clogged, always
turn off the power supply, fuse box or circuit breaker and wait until
the motor is completely stopped before attempting to remove any
clogged material.
• Please make sure that the power plug and the AC outlet receptacle is
protected and away from water or pump discharge hose to prevent
accidental electric shock or short circuit.
• Always operate the pump completely submerged in water.
• Avoid dry operation, which will not only lower performance but can
cause the pump to overheat/malfunction, leading to electrical leakage,
shock or premature failure.
• CAUTION:
THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.
• CAUTION:
THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.
• WARNING:
RISK OF ELECTRIC SHOCK - THIS PUMP IS SUPPLIED WITH A GROUNDING CONDUCTOR
AND GROUNDING-TYPE ATTACHMENT PLUG. TO REDUCE THE RISK OF ELECTRIC SHOCK,
BE CERTAIN THAT IT IS CONNECTED ONLY TO A PROPERLY GROUNDED, GROUNDING
TYPE RECEPTACLE.
Before You Start
• Check the model name plate to make sure once again that the product
is of the correct voltage and frequency rating.
• The setting on the circuit breaker or other overload protector should
be made in accord with the rated currency of the pump.
• Turn off the power supply or circuit breaker before inserting the power
supply plug to avoid electrical shock, shorting, or unexpected starting
of the pump, which could lead to injury.
• Never operate the pump while it is suspended in air. The recoil may
result in injury or other major accident.