Atlantic Water Gardens PAF-20 - Manual (Page 6)

6
Monthly Inspection
• Check for any drop in performance. Reduced performance is usually
caused by debris blocking the intake screen.
• Detach the power cable from the receptacle and turn off the power
supply (circuit breaker).
• Disconnect the pump discharge and remove the pump from the water.
• Remove any accumulated debris from the surface of the pump, inlet
screen and impeller.
• Make sure all nuts and bolts are fastened securely.
• Do not disassemble the pump for any reason. Disassembly will void
the pump warranty. Refer operating and maintenance problems to a
qualified technician.
Winterizing
• Under no circumstances should the pump be left in frozen water.
• When the pump is out of use for an extended period, wash it and dry
it thoroughly, then store it indoors.
Note: Always run a test operation before putting the pump back into
operation. When the pump is left installed in water it should be run at
regular intervals (about once per week).
Warranty
All TidalWave Pumps carry a two-year limited warranty. This limited 2-year
warranty is extended solely to the original purchaser commencing from the
date of original purchase receipt and is void if any of the following apply:
• The pump has been run while not fully submersed causing the thermal
protection to trip. Skimmers using inadequate vertical filtration may
create “run dry” conditions.
• The pump was not run on a dedicated circuit.
• The cord has been cut or altered.
• The pump has been misused or abused.
• Serial number tag has been removed.
• The pump has been fully or partially disassembled.