Eneo PXD-1020F02 - Manual (Page 13)

13
DE
EN
FR
PL
RU
Installation
1. Drill two holes in the ceiling or the wall, to match the spacing of the
mounting holes in the base plate.
1a External use: Drill a hole in the ceiling or wall, to run the Ethernet cable
through. Place the rubber seal rings on either side of the hole in the base
plate.
2. Align the dome base with the previously drilled holes and secure it with
the mounting screws passed through the mounting holes.
3. Adjust the camera angle and focus.
4. Fit the cover onto the dome base and tighten the screws with the Torx
wrench.