Eneo HDD-1012PTZ1080 - Manual (Page 18)

18
A. Make screw holes on the ceiling using the supplied mounting Template
Sheet (Figure A).
B. Fix the Mounting Bracket to the ceiling using supplied Anchors (4x) and
Mounting Screws (4x) (Figure B).
C. Hook up the Safety Lanyard to the Safety Lanyard Hook of the Mounting
Bracket (Figure C).
D. Align the locking tab on the bracket and the locking slot on the base of
the dome (Figure D).
E. Turn the dome to the counterclockwise about 10 degree to the locked
position (Figure E).
CAUTION: Before installing mounting bracket to surface pre-adjust
the four mounting screws „A“ on the base of the dome camera to
best match the mounting bracket locked position. Unscrew the
locking screw on the side of the dome‘s base and fit the tab of the moun-
ting bracket into the locking slot. Screws „A“ should not be too tight or too
loose when the dome is in the locked position. After setting the proper
positions of screws „A“ remove the mounting bracket and install it to the
proper surface. If it is too difficult to lock the dome in position after the
mounting bracket has been installed readjust the screws „A“ by unscrewing
them a small amount and try to install dome camera again.
Setup
Setting Dome Camera Address (ID)
To prevent damage, each Dome Camera must have a unique address (ID).
The factory default setting is 1.
Refer to „Dome Communication“ section in the Full Manual for detailed
information.