Earthquake Sound XJ-600R - Manual (Page 9)

Amplifier Specifications
9 Specifications Are Subject To Change Without Notice
POWER OUTPUT
FREQUENCY RESPONSE
TOTAL HARMONIC DISTORTION
SLEW RATE
SIGNAL TO NOISE RATIO
LOAD IMPEDANCE
DAMPING FACTOR
CONTROLS
INPUT CONNECTIONS
OUTPUT CONNECTIONS
MODE SWITCHES
PROTECTION CIRCUITRY
POWER REQUIREMENTS
SIZE AND WEIGHT
RACK MOUNT SPACE
1 x 700 watts RMS @ 2-Ohms
1 x 570 watts RMS @ 4-Ohms
1 x 320 watts RMS @ 8-Ohms
10Hz - 2.4kHz
<0.08%, (1W/4ohm)
50 volts / microsecond
> 89dB (balanced) 85dB (unbalanced) @ rated power
2 ohms or greater
> 500
XLR / RCA • High-level
Binding posts
Phase switch 0° - 180° - Variable time delay 0 to 20 millisecond
Short circuit, open circuit, RF burnout, over temp,
protection, DC protection, limiter circuitry
turn on/off transient
Power • Room equalization • Room equalization IN/OUT • Subsonic
filter • Phase shift • Lowpass, Bypass • Channel and power status
LEDs • Dual gains internally mixed • Music sensing ON/OFF • DC
turn ON/OFF
110-120VAC~/60Hz
110V-240V~/50Hz
H=1-3/4" x W=19" x D=14-1/2"
44mm x 483mm x 367mm
18.76lbs. • 7.6Kg
1U
XJ-600R Subwoofer Power Amplifier