H3C Technologies H3C S12500 Series Switches - Manual (Page 74)

64
Task Command Remarks
In standalone mode, reboot a
card, or the switch
immediately.
reboot [ slot slot-number ]
Available in user view.
If you reboot the active MPU or do not
specify the slot keyword, the reboot
command reboots the switch.
In IRF mode, reboot an IRF
member switch, a card on the
switch, or all IRF member
switches.
reboot [ chassis chassis-number
[ slot slot-number ] ]
Available in user view.
If you reboot the active MPU or do not
specify the slot keyword, the reboot
command reboots the member switch.
To schedule a reboot:
Task Command Remarks
Specify the reboot date and
time.
schedule reboot at hh:mm [ date ]
Available in user view.
By default, the scheduled reboot
function is disabled.
Specify the reboot delay time.
schedule reboot delay { hh:mm |
mm }
Available in user view.
By default, the scheduled reboot
function is disabled.
Managing the power supply system
You can use the following display commands and proper configuration commands to manage the power
supply system of your switch.
Displaying the electrical label data for the power monitoring
module
Use the display device manuinfo power-monitor command to display the electrical label data for the
specified power monitoring module.
• In standalone mode:
# Display the electrical label information about power monitoring module 2.
<Sysname> display device manuinfo power-monitor 2
Power Monitor unit 2:
DEVICE_NAME : PMU
DEVICE_SERIAL_NUMBER : 210235A36L1234567890
MAC_ADDRESS : NONE
MANUFACTURING_DATE : 2010-01-20
VENDOR_NAME : H3C
• In IRF mode:
# Display the electrical label information about power monitoring module 2 on member switch 1.
<Sysname> display device manuinfo chassis 1 power-monitor 2
Chassis 1:
Power Monitor unit 2:
DEVICE_NAME : PMU2