H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 11)

4
NOTE:
You can create VLANs on the Ten-GigabitEthernet interface connecting the switch and the access
controller module LSQM1WCMB0, LSQM1WCMD0, LSBM1WCM2A0, LSRM1WCM2A1, or
LSRM1WCM3A1, and then configure the port of the switch.
Configuration procedure
1. Configure the switch:
<Switch>system-view
# Create VLAN 8 through VLAN 10.
[Switch]vlan 8 to 10
# Configure the port of the switch.
[Switch]interface Ten-gigabitethernet4/0/1
[Switch-Ten-GigabitEthernet4/0/1]port link-type trunk
[Switch-Ten-GigabitEthernet4/0/1]port trunk permit vlan 8 to 10
2. Configure the access controller module:
<Switch>oap connect slot4
<AC>system-view
# Create VLAN 8 through VLAN 10.
[AC]vlan 8 to 10
# Configure the port of the access controller module.
[AC]interface Ten-gigabitethernet 1/0/1
[AC-Ten-GigabitEthernet1/0/1]port link-type trunk
[AC-Ten-GigabitEthernet1/0/1]port trunk permit vlan 8 to 10
Configuring LSWM1WCM20 or LSWM1WCM10
Network requirements
Insert an access controller module in the switch. Packets on VLAN 1, and VLAN 8 through VLAN 10 are
permitted to transfer between the switch and the module. By default, packets on VLAN 1 are permitted
to transfer between the module and the switch.
NOTE:
•
For access controller module LSWM1WCM20, you need to first aggregate the two GigabitEthernet
ports connecting the switch and the access controller module, create VLANs on the aggregation port,
and then configure the port of the switch. By default, two GigabitEthernet ports connecting the switch
and the access controller module are aggregated.
• You can create VLANs on the Ten-GigabitEthernet interface connecting the switch and the access
controller module LSQM1WCMB0, LSBM1WCM2A0, or LSRM1WCM2A1, and then configure the port
of the switch.
Configuration procedure
1. Configure the switch:
<Switch> system-view
# Create VLAN 8 through VLAN 10.
[Switch] vlan 8 to 10