Activating on an h3c secpath t5000-s3, Configuration guidelines, Activation procedure – H3C Technologies H3C SecBlade IPS Cards User Manual
Page 15
10
Figure 11 License Import tab
Step3
On the License Import tab, click Browse to select the activation file and click Import. The activation file
will be imported and the license will be activated on the IPS.
Activating on an H3C SecPath T5000-S3
Configuration guidelines
•
A SecPath T5000-S3 IPS has two service cards that use separate licenses. You must register both
licenses to activate the two cards.
•
The default management interfaces of the master board and the service cards use the same IP
address 192.168.1.1. To avoid address conflict, assign these interfaces different IP addresses on the
same segment.
Activation procedure
Step1
Connect the devices and log in to the web management interface of the T5000-S3 master board.
Use a crossover Ethernet cable to connect the network interface of the PC to the default Ethernet
management interface of the T5000-S3 master board. By default, the IP address of the default Ethernet
management interface is 192.168.1.1. Configure the IP address of the PC, 192.168.1.2 in this example.
Make sure the devices can reach each other.
Figure 12 Network diagram
Launch an IE browser and enter https://192.168.1.1 in the address bar. The login page shown in
appears. Type the username admin, the password admin, the verify code, select English, and click
Login.