H3C Technologies H3C SecPath M9000 Series - Manual (Page 7)

4
Figure 4 Attaching cable management brackets to an M9006
(1) Attach the cable management bracket to the chassis
(2) Screw holes for installing the cable management bracket
(3) Screws for attaching the cable management bracket to the chassis
(4) Power cable management bracket (installed at the lower part of the chassis)
Installing mounting brackets
Marks L and R are printed inside the mounting brackets to distinguish between the left and right mounting
brackets. To install the mounting brackets, face the front of the gateway, and mount the left and right
mounting brackets to the two sides of the gateway, as shown in Figure 5 .
Figure 5 Installing the mounting brackets (M9006)
(1) Screws for attaching the mounting brackets to the chassis (2) Mounting brackets
(3) Signal cable management brackets
1
2
3