Caution – Exmark Lazer Z CT User Manual
Page 28
23
b) Raise deck to the transport (4.5” (11.4cm) cutting height) position. Lift the
front of unit and support unit using jack stands or equivalent support.
CAUTION
POTENTIAL HAZARD
♦ Raising the mower deck for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may
not be enough support or may
malfunction allowing the unit to fall, which
could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or
hydraulic jacks for support. Use adequate
jack stands or equivalent support.
c) Clean out any grass build-up from underside of deck and in discharge chute.
4.1.5 Check mower blades.
Service Interval: Daily
a)
Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b)
Lift deck and secure in raised position as stated in Section 4.1.4.
c)
Inspect blades and sharpen or replace as required.
d)
Re-install the blades (if they were removed) in the following order (See
Figure 3):
1) Install bushing through blade with bushing flange on bottom (grass)
side of blade.
2) Install bushing/blade assembly into spindle.
3) Install blade bolt and spring disc washer. Be sure the spring disc
washer cone is installed towards the bolt head. Place wrench on the top
spindle nut torque the blade bolts to 55-60 ft-lbs. (75-81 N-m).
FIGURE 3