Exmark Lazer Z CT - Manual (Page 40)

35
h) Bring the RH motion control lever into the neutral position. Adjust RH pump
control rod length by rotating the double nuts on the rod in the appropriate
direction until the wheels slightly creep in reverse (See Figure 9). Move the
motion control lever to the reverse position and while applying slight pressure
to the lever, allow the reverse indicator spring to bring the levers back to
neutral. The wheel must stop turning or slightly creep in reverse.
NOTE: The motion control lever needs to be in neutral while making
any necessary adjustments.
The left rod assembly controls the left wheel and the right rod assembly
controls the right wheel.
i) Bring the LH motion control lever into the neutral position. Adjust the LH
pump control rod length by rotating the tracking adjustment knob in the
appropriate direction until the wheels slightly creep in reverse. Move the
motion control lever to the reverse position and while applying slight
pressure to the lever allow the reverse indicator spring to bring the levers
back to neutral. The wheel must stop turning or slightly creep in reverse.
See Figure 10.
FIGURE 10
j) Shut off unit. Remove jumper wire from wire harness connector and plug
connector into seat switch.