Grass Valley 2030RDA - Manual (Page 8)

8 2030RDA Instruction Manual
Installation
Installation
Installation of the 2030RDA module is a process of:
1. Placing the CoaxPRM (passive rear module) in a frame slot,
2. Setting jumper J24 on the 2030RDA front media module for Local or
Remote operation (see
Remote Control Jumper on page 15 ) then installing
the module in the corresponding front slot, and
3. Cabling signal ports.
The 2030RDA module can be plugged in and removed from a 2000 Series
frame with power on. When power is applied to the module, LED indica-
tors reflect the initialization process (see
Power Up on page 12 ).
Module Placement in the 2000 Frame
There are twelve slot locations in both the front and rear of a 3 RU frame
and four slot locations in a 1 RU frame to accommodate 2000 and Kameleon
Series media modules (audio/video signal handling modules).
The 2030RDA consists of a two-module set with a processing module and
a passive rear module that can be plugged into any of the frame slot pairs.
The rear modules provide the input and output interface connectors.
To install a 2031RDA module set in a 2000 Series frame:
1. Locate a vacant slot in the rear of the 3 RU frame ( Figure 1 ) or the
2000T1DNG frame ( Figure 2 on page 9 ).
Figure 1. 2000T3 Frame, Rear Slots
Media section
rear slots 1-6
(with two 2000EMI blanks)
Media section
rear slots 7-12
Network
and reference
input connections
Power, frame
configuration,
& frame health
connections
8031_11