Grass Valley 8947RDA-D - Manual (Page 20)

20 8947RDA-D/-FR — Instruction Manual
Cabling
Cabling
Cabling to the 8947RDA-D or 8947RDA-FR module is done on the BNCs
and/or the fiber connector on the rear module (when an optional fiber
optic SFP device is installed on the 8947RDA-FR) as described in these sec-
tions:
• 8947RDA-D Module Cabling on page 22
• 8947RDA-FR Module Cabling on page 23
Video Input(s)
The 8947RDA-D and 8947RDA-FR will accept any of the SD or HD SDI
video standards listed in the input specifications in
Table 7 on page 53 .
For the 8947RDA-FR, the video input(s) to the module can be selected from
one of the following sources, depending on the presence and type of
optional fiber optic SFP device:
• Electrical BNC, J9 (always available),
• Fiber RX 1 with Dual Receiver fiber optic SFP device or Transceiver
fiber optic SFP device installed (see
Table 3 on page 18 for part
number), or
• Fiber Input RX 2 with Dual Receiver fiber optic SFP device installed,
(see
Table 3 on page 18 for part number).
All input sources can be connected but only be one input can be active at
any time. The active input is configured with local onboard controls (
Con-
figuration Switches S1 and S2 on page 15 ) or using the Settings web page
( page 33 ). The video input type (SD or HD) is selected in configuration
when the reclocking mode is set to Bypass.