Grass Valley 8985PRC v.1.1.0 - Manual (Page 22)

22 8985PRC — Instruction Manual
Configuration
Color Correction
Color correction controls are provided for making RGB gain, offset and
gamma correction adjustments. Each color channel can be adjusted sepa-
rately or a total gain or total gamma can be applied to all channels.
Gamma controls brighten and darken the gray intensity of the signal.
Raising the gamma above 1.0, brightens the gray intensity. Lowering the
gamma below 1.0, darkens the gray intensity.
Video Processing Adjustments
Component level (Y, Cr, Cb) adjustments are provided in the Video pro-
cessor for video gain and offset, chroma gain, phase control (hue), and color
saturation. Each color component can be adjusted separately or the total
gain can be adjusted.
User Settings
Module default parameters and default signal names can be recalled at any
time for the entire module or subsets of parameters such as the color cor-
rector or video processor.
On the web pages, a Defaults button at the bottom of each applicable web
page is available to return the parameters on that page to the factory
defaults.
Save and load module configuration to/from a file are also provided on the
web pages.
Video Outputs
When there is a Dual Transmitter (2 outputs) or Transceiver (1 output) fiber
optic submodule installed, one or both fiber outputs must be enabled for
operation.
The SD or HD horizontal video output delay can also be set in pixels.