Grass Valley 3e Student CameraMan Rev.B - Manual (Page 5)

1-CCD or 3-CCD
Camera Control
Keypad.
System Components
Your Student Camera System includes a Programmable Response Module, Power Supply, a 1-CCD or 3-CCD Camera Control Keypad,
and connection accessories. To set up your system, you will also need an audio mixer and microphones. These are not included
with your system.
Low Profile Microphones are recommended for better camera control.
“Voice-activated” microphones may pick up background noise and cause
unwanted camera motion.
Camera Control Keypad
The included Camera Control Keypad gives you the ability to control the camera’s pan and tilt
movement, focus, and IMAGE, as well as store and recall up to 99 camera presets (125 for 3-
CCD cameras).
See the included Camera Control Keypad Operations Manual for information on
setup, configuration and use of the keypad.
Power Supply
The Included Power Supply enables use with 120-240VAC, 50/60 Hz sources.
Connection Accessories
• 10’ RS-485 CameraMan Communication Cable
• CameraMan RS-485 “T” Connector
• 3 ft. RS-485 CameraMan Communication Cable
If you have purchased this as an upgrade, it will include all components except the
Camera.
Front of PRM with configuration plate
attached
Power Supply
left: top of
T-connector
with RS-485
cables.
right: front of
T-connector