Executing a sequence, Assigning a sequence to a button – Grass Valley JEP-100 v.1.2.0 User Manual
Page 60
58
JEP-100 — Installation and Operating Manual
Section 1 — JEP-100 Control Panel
Executing a Sequence
After a sequence is created and downloaded, it can be executed as follows:
1.
SALVO button - On.
The name of the first sequence (e.g., "SETUP1") will be shown in the
Status window.
2.
Use UP/DOWN to scroll to the desired sequence.
3.
Press TAKE to execute the sequence.
Assigning a Sequence to a Button
The 96 keys on the left side of the JEP can be assigned to individual
sequences. Pressing the assigned button will then execute the se quence.
1.
ASSIGN button - On.
2.
SALVO button - On.
The name of the first sequence (e.g., "SETUP1") will be shown in the
Status window.
3.
Use UP/DOWN to scroll to the desired sequence.
4.
Press one of the desired 96 keys on the left side of the panel.