Electrolux EWN 14780 W - Manual (Page 39)

installation electrolux 39
The drain hose may be extended to a
maximum of 4 metres.
An additional drain hose and joining
piece is available from your local
Service Force Centre. The joining piece
must have an internal diameter of 18
mm.
If your drain hose looks like this (see
below) you do not require the «U»
piece. Just push the hose firmly into
the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used
before, remove any blanking plug that
may be in place.
P1197
P1212
M
in . 60 cm (23
.6”)
M
ax
. 90 cm (35
.4”)
3 pin
HEC0012
Push the drain hose onto the spigot
and secure with a clip if required,
ensure a loop is formed in the drain
hose (see diagram) to prevent waste
from the sink entering the washing
machine.
Important!
Before connecting the machine to new
pipework or to pipework that has not
been used for some time, run off a
reasonable amount of water to flush
out any debris that may have collected
in the pipes.
Special conditions
If the floor is carpeted or covered with
crumbly or soft material, insert a rigid
support base under the feet to prevent
noise, vibration or displacement. The
base should protrude a few
centimetres beyond the edges of the
machine.
Warning !
The machine should NOT be placed on
deep pile carpeting.
P1198
Loop
132972160 EN.qxd 30/03/2007 15.43 Pagina 39