Grass Valley Maestro Master Control Branding Engine v.1.6.0 - Manual (Page 46)

46 Maestro — Branding Engine Quick Start Guide
Section 2 — Hardware Installation
Figure 22. Branding Engine Disk Drive Mounting Hardware
To install a Branding Engine disk drive, do the following:
Note Steps 1-3 are necessary only if replacing the drive supplied by Grass Valley
with a different drive. In this case, the mounting sled must be removed from
the old drive and mounted on the new drive.
1. Position the hard drive with the circuit board side facing up.
2. Position the drive sled on the drive so that the four screw holes in the
sled are aligned with the screw holes in the drive. See
Figure 23 .
Figure 23. Drive Sled Aligned on Disk Drive