Grass Valley NV5256 v.1.8 - Manual (Page 51)

NV5256 Machine Control Router • User’s Guide 43
7. Misc. Topics
Chapter 7 provides the following:
• Control Port Connectors
• AES Reference Connectors
• Ordering Information
Control Port Connectors
There are two sets of these connectors — one for the primary control card and one for the redundant
control card.
CTRL1, CTRL2 DIAG
The connectors are female DE9s.
AES Reference Connectors
There are two sets of AES reference connectors, one for the primary control card and one for the
secondary control card. You can use either the BNC connector or the Phoenix 3-pin STP connec-
tors. This figure shows the pinouts of the Phoenix connectors:
1
6 9
5
3 Rx+ 4 Gnd
1 Gnd
2 Tx– 5 n.c.
6 Gnd 9 Gnd
7 Tx+ 8 Rx–
1
6 9
5
3 Rx+ 4 n.c.
1 n.c.
2 Tx– 5 n.c.
6 n.c. 9 n.c.
7 Tx+ 8 Rx–
AES
REF
1
AES
REF
2
PRI CTRL SEC CTRL
AES2 Shield
AES2–
AES2+
BNC
AES1 Shield
AES1–
AES1+
1 2 3 1 2 3