Grass Valley Profile Mix Effects Upgrad 100 Fibre Channel - Manual (Page 37)

Preparing the Profile System
PDR 100 Fibre Channel Installation 37
If necessary to remove an Ethernet 10 BaseT board, which is a short board, see
Figure 12 for an example and:
1. Use the Torx tool with the T15 tip to remove the board bracket retaining
screw from the inside of the rear panel.
2. Carefully but firmly grasp the board and lift it straight up and out of the
chassis. Note that you may have to remove an adjacent full size board in order
to safety grasp the Ethernet 10 BaseT board.
Figure 12. Typical Removal of a Short Board
9674-18