Grass Valley RS-422 Interface Board - Manual (Page 33)

Installing the RS-422 Interface Board Device Driver
RS-422 Interface Board Installation 33
9. From the Advanced menu (see Figure 14), select Options to open the
Advanced Board Options dialog box as shown in Figure 15.
a. Set the
Scan Rate(ms) to 2ms by selecting the text in the text box and
entering 2. Note that 2 is not in the drop down list, you must enter it using
the keyboard.
b. Click OK to close the Advanced Board Options dialog box.
Figure 15. The Advanced Board Options dialog box settings
10. In the RocketPort/RocketModem NT Setup window, select OK to accept
your changes, and then OK again to make a new program group.
NOTE: If necessary, close the Explorer window showing the new program
folder contents in order to see the remaining dialog boxes.
11. Chose OK to make changes to the modem.inf file.
12. Chose OK to save new configuration settings.
13. Click Close in the Network dialog box.
14. Remove the floppy disk from the drive and, when prompted, restart the
system. Logon as Profile. The factory default password for the Profile user
account is profile.