Grass Valley T2 Classic iDDR Workstation Mode SP2 - Manual (Page 35)

T2 ― UserManual(SP2) ― Workstationmode ― 35
Hardwaresettings
GPI settings
Input settings
GPI-Input Use the Previous and Next buttons to choose the GPI input trigger.
Trigger settings
Permits specification of the GPI input trigger settings.
Channel
Choose a channel to respond to the GPI input trigger.
Action
Specify the action caused by the trigger.
• Stop ............................Stops playback/recording.
• Play ............................. Plays the clip or playlist loaded to a channel.
• Record ........................Starts recording.
• Rewind ........................ Rewinds. Rewinding stops at the start of the
content, or when other action is performed.
• FastFwd ...................... Executes Fast Forward. Fast Forward stops at the
end of the content, or when other action is
performed.
• CueStart ...................... Cues up to the IN point of the content loaded.
• CueEnd ....................... Cues up to the OUT point of the content loaded.
• Eject ............................ Unloads the content loaded.
• Preview ....................... Loads the clip uploaded from the R1 channel onto
the P1 channel.
• CueNextEvent .............. Cues up to the next event on the playlist loaded.
• CuePrevEvent .............. Cues up to the previous event on the playlist
loaded.
• VARPlayback ................ Plays the content in the speed specified in Variable
speed playback mode (see “Jog/Shuttle settings").
Active
Choose the GPI signal to activate from High and Low.