Grass Valley Turbo iDDR Rack-Mount Kit - Manual

Turbo™ iDDR Rack-Mount Kit
Instructions
These instructions describe how to install the Turbo iDDR in standard equipment
racks using the optional rack-mount kit.
Information here includes:
• “Before you begin” on page 1
• “Rack mount hardware shipped with the iDDR” on page 2
• “Mounting the Rack Slides” on page 3
• “Installing the rack-mount kit” on page 5
• “Installing the iDDR on the rack mount rails” on page 6
• “Grass Valley Product Support” on page 7
Before you begin
When planning the placement of equipment in your equipment rack, bear in mind the
following:
• Insure adequate air flow around the chassis to provide sufficient cooling. Operating
ambient temperature will affect the amount of air circulation required to keep the
iDDR within its temperature limitations. See the Turbo iDDR User Manual for
environmental specifications.
• If the system is installed with its ventilation intakes near another system's exhaust
or in a closed or multi-unit rack assembly, the operating ambient temperature
inside the chassis may be greater than the room's ambient temperature. Install the
system in an environment compatible with the recommended maximum ambient
temperature.
• Ensure the rack is anchored to the floor so that it cannot tip over when the iDDR is
extended out of the rack.
• Be sure to mount the iDDR in a way that ensures even weight distribution in the
rack. Uneven mechanical loading can result in a hazardous condition. Secure all
mounting bolts when installing the chassis to the rack.
The following sections describe installing the Turbo iDDR rack-mount kit
step-by-step.
Copyright © 2005 Thomson Broadcast and Media Solutions, Inc. All rights reserved. Printed in the United States of America.
This document may not be copied in whole or in part, or otherwise reproduced except as specifically permitted under U.S. copyright law, without the prior written consent of
Thomson Broadcast and Media Solutions, Inc., P.O. Box 59900, Nevada City, California 95959-7900
Grass Valley, Turbo, Profile, and Profile XP are either registered trademarks or trademarks of Thomson Broadcast and Media Solutions, Inc. in the United States and/or other
countries. Other trademarks used in this document are either registered trademarks or trademarks of the manufacturers or vendors of the associated products. Thomson
Broadcast and Media Solutions, Inc. products are covered by U.S. and foreign patents, issued and pending. Additional information regarding Thomson Broadcast and Media
Solutions, Inc.s trademarks and other proprietary rights may be found at
www.thomsongrassvalley.com .
Product options and specifications subject to change without notice. The information in this manual is furnished for informational use only, is subject to change without notice,
and should not be construed as a commitment by Thomson Broadcast and Media Solutions, Inc. Thomson Broadcast and Media Solutions, Inc. assumes no responsibility or
liability for any errors or inaccuracies that may appear in this publication.
*071-8398-01*