Grass Valley Turbo iDDR Rack-Mount Kit - Manual (Page 6)

6 Turbo iDDR Rack-Mount Instructions July 21, 2005
Installing the iDDR on the rack mount rails
Installing the iDDR on the rack mount rails
To install the iDDR on the rack mount rails:
1. Pull the slide-out track section to the fully extended position.
WARNING: To prevent injury, two people are required to lift the iDDR.
It is too heavy for one person to install in the rack.
WARNING: To prevent serious injury, insure that the rack is anchored
to the floor so that it cannot tip over when the iDDR is extended out of
the rack.
2. Insert the ends of the chassis sections into the slide-out sections.
3. Push the chassis toward the rack until the chassis sections lock into the intermediate
sections.
4. Press the stop latches in the intermediate sections and push the chassis toward the
rack until the latches snap into their holes.
5. Again, press the stop latches and push the cabinet fully into the rack.
6. Insert and tighten the front retaining screws.
Making Rack Slide Adjustments
After installation, binding may occur if the slide tracks are not properly adjusted. To
adjust the tracks:
1. Slide the chassis out approximately 10 inches.
2. Slightly loosen the mounting screws holding the tracks to the front of the rails and
allow the tracks to seek an unbound position.
3. Tighten the mounting screws and check the tracks for smooth operation by sliding
the chassis in and out of the rack several times.
4. Tighten the front retaining screws once the cabinet is in place within the rack to
complete the installation.
!
!
Stop Latch